John Hollenberg
New member
I have had an Epson 2400 for about 2 months. Everything has been going fine, except that it has needed 6 cleaning cycles already which is more than my 2200 needed for an entire year. Last night I had to do 3 cleaning cycles, then replaced a low cartridge this AM. One of the nozzle checks had a magenta droplet on it (approx 0.5 mm). The nozzle check this AM after replacing the low cartridge was perfect. However, when I made a print, there were about 6 or 8 black dots (approx. 0.5 mm) scattered over a 3 X 4 inch area of the sky. This was on a 12X18 print.
Does anyone know what is causing these droplets? I have never seen anything like this from any of my Epson printers. It may be a temporary aberration related to the cleaning cycles, but since the printer seems to be clogging quite a bit I am concerned the problem may continue or get worse.
--John
Does anyone know what is causing these droplets? I have never seen anything like this from any of my Epson printers. It may be a temporary aberration related to the cleaning cycles, but since the printer seems to be clogging quite a bit I am concerned the problem may continue or get worse.
--John